Last Updated on October 14, 2022 by Douglas
This article will show you how to jack up a travel trailer.
There are two ways to do this, the first is with a car jack. The second is with a hydraulic jack. In this article we will be looking at the car jack method.
Where do you place a jack on a travel trailer?
Next, chock the trailer wheels on the side opposite that which you intend to jack. Place the jack under the frame just behind the rear axle (never on the axle itself or any of the vehicle’s suspension components).[1]
How do you change a tire on a travel trailer?
Find a Secure Place to Pull Over. Loosen the Nuts on Your Flat Tire. Pull Onto a Ramp Jack. Secure Your RV With Tire Chocks. Remove Lug Nuts and Old Tire. Replace With Your Spare. Remove Chocks and Drive Off Ramp Jack.[2]
How do you jack up a torsion axle trailer?
If you want to jack up the whole trailer, front and back and both sides, you can use the tongue jack for the front and then use a floor jack to jack up one corner at the back of the trailer, place a jack stand to hold it, and then jack up the other side using a jack stand to hold it as well.[3]
How do I level my travel trailer?
The easiest way to do this is to place the level on the tongue of the trailer. This will let you know if one side is higher than the other, which will inform which side you want to raise. Now that you know which side is too low, put boards or leveling blocks behind the wheels you need to raise.[4]
What size jack do I need for a travel trailer?
To determine the trailer jack capacity needed to support a trailer, you first take the gross trailer weight and then multiply it times . 15 to get the theoretical tongue weight. Pick out a jack that will support that weight, and has a safety margin that you are comfortable with.[5]
What size jack do I need for a motorhome?
The required weight capacity of tongue jack is determined by calculating the tongue weight of your trailer. The rule of thumb for a boat trailer is 7-10% of the weight of your fully loaded trailer. If you have a 6000lb loaded trailer, using 10% as an example, you would require a tongue jack with a capacity of 600lbs.[6]
Can you use RV leveling jacks to change tires?
Note: Leveling jack manufacturers advise not to use leveling jacks to change a tire, or to do any type of service or maintenance under the trailer when the jacks are the only support. Never lift all the tires off the ground without blocking, or jacks to support all the weight of the trailer.[7]
How many years do travel trailer tires last?
Time Considerations The common rule of thumb for changing your RV tires is anywhere between three and six years. If you are on the road often, and you think your tires need to be changed, then it may not be possible to last as long as six years.[8]
Do you need to replace trailer tires in pairs?
Expert Reply: The best practice is honestly to replace tires in pairs. That way they should wear at the same rate and they’ll be on the same replacement rotation.[9]
Where do you jack the torsion axle?
jack right under where it bolts to frame. The jack is less likely to bend the axle there than spindle/hub/tire would be.[10]
How do you lift a trailer suspension?
One common way to lift your trailer is by “flipping” your axles. Flipping your axles just means moving your suspension from below the axle (standard, “underslung” springs) to above the axle (“overslung” springs) in order to create more clearance between the underside of the trailer and the road.[11]
Do torsion axles wear out?
It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle.[12]