How to Level Travel Trailer on Slope

Last Updated on September 21, 2022 by Douglas

The following steps are necessary to level a trailer on a slope.

1. Put the trailer in gear and drive it forward until the front of the trailer is even with the back of the trailer.

2. Put your hand on top of the tongue and push it down until it is even with the ground.

3. Drive forward again, but this time steer so that you are driving up onto your hand, rather than driving straight ahead as before

4. Drive up onto your hand until you feel resistance from your hand pushing against the ground, then stop and put your other hand on top of your first one to push down

5. Drive forward again, steering so that you are driving up onto both hands rather than driving straight ahead as before

6. Continue to drive

How do you level an RV on uneven ground?

When you arrive, park the front end of the RV to the downhill side of an uneven campsite or parking space. Place blocks or jack pads under your jacks. Use your control panel to level your RV using your Auto-Leveling System.[1]

Where is the best place to level a travel trailer?

The easiest way to do this is to place the level on the tongue of the trailer. This will let you know if one side is higher than the other, which will inform which side you want to raise. Now that you know which side is too low, put boards or leveling blocks behind the wheels you need to raise.[2]

Does RV need to be perfectly level?

If your RV is not level, you are adding stress to many areas including door frames, plumbing, cupboards, and even the chassis. An RV was built to be level so you could be causing long term issues and damage if you are using it without it being properly leveled.[3]

Is it OK to store a travel trailer unlevel?

In a storage situation (fridge is off)unleveled is the way to go, helps the water run off faster. I park on our concrete driveway which is level side to side, but I always raise it so it is high in the front by about an inch. Unless you want to run the fridge, you should be fine.[4]

How unlevel can an RV be?

How level does an RV need to be? An RV should be level within 1 – 2 degrees from the plum. Visually, this would be about half a bubble on a bubble level. It should be leveled from side to side and then from front to back.[5]

How do you level a trailer with a sloped driveway?

So how do you level a travel trailer on a slope? Begin by leveling the travel trailer from side to side, chock the wheels and then level it from front to back by adjusting the tongue jack. When done properly your travel trailer will be stable and ready for you to safely enjoy.[6]

Why does my camper shake when I walk in it?

You may be asking yourself, why is my travel trailer shaking? The answer could be many reasons, including that you aren’t parked on a level surface, your trailer is unevenly weighted, you may need wheel chocks and stabilizers, or there are simply people walking around inside the travel trailer![7]

How do you level a camper without moving it?

Generally, you can level a camper without moving it using an auto-leveling system or a wedge system. However, larger campers can take longer to level, and some large campers do need to be moved to level properly depending on what they have on board and if they have an auto-leveling system.[8]

What happens if your trailer is not level?

An unlevel trailer will put extra weight on one axle rather than an equal weight distribution between all of the axles. Obviously, this will cause excessive tire wear to the tires that have more weight on them. If your trailer is nose high, you may notice your rear axle tires being more “flattened” than the front.[9]

How much does it cost to level a RV?

Auto RV leveling systems will typically cost between $2,000 and $5,000 for the system itself. If you want to have it professionally installed, you’ll typically be looking at installation fees of $500 to $1,000+, depending on the system, your RV, and where you have it done.[10]

Do you level your RV with slides out?

So what’s the right answer? Level and put your slides out according to your RV’s user manual. Any professional should tell you that the typical recommendation is to level first, then put your slides out. However, they’ll also state you should go with what your manufacturer states in your owner’s manual.[11]

How do you level a parked travel trailer?

Choose Your Site. Clear the Area of Debris and Clutter. Check Your Travel Trailer With A Level. Place Leveling Blocks Near Your Travel Trailer’s Tires. Bring the RV onto the Blocks. Install the Wheel Chocks. Slowly Start Lowering The Tongue Jack.[12]

Leave a Comment